Hi all, Are SATA drives not supported by the BDI? I successfully did an install etc. on a system with IDE drives, but now when I try to do it on one with SATA drives I immediately get the notice "No hard drives have been found. You probably need to manually chose device drivers for the installation to succeed. Would you like to select drivers now?" The system does in fact have two SATA hard drives. I tried several of the options for installing drivers manually or custom setup, but the necessary drivers are never listed. However proceeding as far as I can with the install invariably ends up with the message "An error has occurred - no valid devices were found on which to create new file systems. Please check your hardware for the cause of the problem." Any ideas? Thanks, Eric