2 Sep
2007
2 Sep
'07
7:50 p.m.
Hi Shabbir On Sunday 02 September 2007 06:26, moghul shabbir wrote:
PLEASE TELL ME IN DETAIL ABOUT EMC? IS EMC FULL CLOSE LOOP SYSTEM TO SOFTWARE ?
Please, don't type everything in capitals... Yes, EMC can be used as a full closed loop system with suitable encoders and interface card - The motors can be either DC servos or stepper motors, although to run closed loop with steppers, you would need to make a few small changes to the code (which is readily available). Depending on the interface cards used, you can run up to six axis of simultaneous coordinated motion. If you have any further specific questions, do not hesitate to ask. Regards, Paul.