[Bdi4emc-help] Re: Jeff's instructions

[Kent A. Reed]

Jeff:

Folks on the emc-lists tend to tell folks asking about compiling emc or 
emc2 on bdi to redirect their questions to this bdi-list. Sometimes this 
Frick and Frack action is amusing, sometimes it's annoying, but it 
always gets in the way of progress.

Following in this vein, how about cross-posting your instructions on 
Paul's Wiki, since that's where the linuxcnc site directs bdi users?

Just my $0.02 worth.

Regards,
Kent
> Date: Wed, 15 Mar 2006 21:18:02 -0600
> From: Jeff Epler <jepler at unpythonic.net>
> Subject: Re: [Bdi4emc-help] Problems of compiling EMC on BDI 4.38
> To: "Help and advice for BDI-4 users."
> 	<bdi4emc-help at lists.ourproject.org>
> Message-ID: <20060316031802.GB29175 at unpythonic.net>
> Content-Type: text/plain; charset=us-ascii
>
>
> I wrote and tested these instructions this past weekend:
> http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl/emcinfo.pl?BDI-4_38_Compile_EMC2
>
> The best place to ask for help compiling emc2 may be the emc-users list.
>     http://lists.sourceforge.net/lists/listinfo/emc-users
>
> Jeff
>
>
>
>