[Bdi4emc-help] RE: Bdi4emc-help Digest, Vol 5, Issue 1

[Paul]

Hi Craig

On Sunday 02 April 2006 19:38, Craigg Gadd wrote:
> I'm very new to Linux but managed to successfully install BDI 4.38 a few
> days ago.  I seem to be having trouble launching EMC however.  The problem
> is that the system hangs when TK starts to load.  I'm saying this based on
> what I'm reading on the script window as EMC is loading.
>
> Once the system is hung, I'm unable to recover and must reboot.  I'll
> mention that I don't seem to be having any other problems with the
> installed applications so I believe the problem relates to EMC and Tk.

This sounds very much like PERIOD being set too low for your computer. This 
parameter is defined in /usr/local/emc/emc.ini, or generic.ini, depending on 
which run script you use.. The value is set at a fairly conservative 0.000025 
and should work with most 400MHz and faster computers. Even a P266 will run, 
but performance would be quite sluggish...

There are one or two motherboards out there that just can not provide adequate 
performance due to inherant design problems - Generally, anything that uses 
shared main memory for onboard video, certain i845/855 chipsets, and Geode 
processors all have "issues".

You could try increasing PERIOD to 0.00005 and see if avoids the freezing. 
Some additional information about your computer (make/model of motherboard, 
graphics card, etc) would help..


Regards, Paul.